iPhone 6 Battery Replacement Steps

  • Power off your iPhone before beginning disassembly.
  • Remove the two 3.6 mm Pentalobe screws next to the Lightning connector.
  • Close the handle on the iSclack, opening the suction-cup jaws.
  • Place the bottom of your iPhone in between the suction cups.
  • Position the iSclack’s upper suction cup against the display, just above (but not covering) the home button.
  • Open the handles to close the jaws of the iSclack. Center the suction cups and press them firmly onto the top and bottom of the iPhone.
  • Hold onto your iPhone securely and close the handle of the iSclack to separate the suction cups, pulling the front panel up from the rear case.
  • Peel the two suction cups off your iPhone.
  • Press a suction cup onto the screen, just above the home button.
  • While holding the iPhone down with one hand, pull up on the suction cup to slightly separate the front panel assembly from the rear case.
  • Using a plastic opening tool, begin to gently pry the rear case down, away from the display assembly, while continuing to pull up with the suction cup.
  • Pull the plastic nub to release the vacuum seal on the suction cup.
  • Remove the suction cup from the display assembly.
  • Open the iPhone by swinging the home button end of the front panel assembly away from the rear case, using the top of the phone as a hinge.
  • Open the display to about a 90Âș angle, and lean it against something to keep it propped up while you’re working on the phone.
  • Add a rubber band to keep the display securely in place while you work. This prevents undue strain on the display cables.
  • Remove the following Phillips screws from the battery connector bracket
  • Remove the metal battery connector bracket from the iPhone.
  • Use a plastic opening tool to gently pry the battery connector up from its socket on the logic board.
  • Remove the following five Phillips screws securing the front panel assembly cable bracket
  • Remove the front panel assembly cable bracket from the logic board.
  • Use the flat end of a spudger to disconnect  the front-facing camera and sensor cable connector,home button cable connector, display data cable connector and digitizer cable connector.
  • Remove the front panel assembly from the rear case.
  • Peel back the first battery adhesive tab from the bottom right edge of the battery.
  • Gently pull the battery adhesive tab away from the battery, toward the bottom of the iPhone.
  • pull it gently around the lower right corner of the battery.
  • Peel back the second battery adhesive tab from the bottom left edge of the battery.
  • pull it gently around the lower left corner of the battery.
  • Flip the iPhone back over and insert a plastic card between the case side of the battery and the rear case.
  • Remove the battery from the iPhone.

Leave a Reply

Your email address will not be published. Required fields are marked *